电容式力感知牙周探针设计建模与实验研究

针对当前牙周探针在探诊力控制方面的不足,提出一种基于悬臂梁挠曲效应的差动电容式力感知牙周探针解决方案,设计了探针验证结构,建立了探诊力作用下具有不规则形状的探针工作尖的挠曲模型,导出了探诊力和差动电容之间的求解方程,并通过仿真和实验对模型与方程进行了验证。结果表明,所建立的探针工作尖挠曲模型与静应力仿真结果的最大相对误差不超过±4.5%,所设计的力感知牙周探针多次重复探诊力检测实验的标准差小于均值的0.1%,所导出的求解方程的计算值与实验数据之间趋向一致,以探诊力为拟合权重进行修正后全量程的平均偏差为2.49%,具备进一步产品开发的可行性。     

基于全U网络的混凝土路面裂缝检测算法

针对现有的混凝土裂缝检测算法在各种复杂环境中检测精度不够、鲁棒性不强的问题,根据深度学习理论和U-net模型,提出一种全U型网络的裂缝检测算法。首先,依照原U-net模型路线构建网络;然后,在每个池化层后都进行一次上采样,恢复其在池化层之前的特征图规格,并将其与池化之前的卷积层进行融合,将融合之后的特征图作为新的融合层与原U-net网络上采样之后的网络层进行融合;最后,为了验证算法的有效性,在测试集中进行实验。结果表明,所提算法的平均精确率可达到83.48%,召回率为85.08%,F1为84.11%,相较于原U-net分别提升了1.48%,4.68%和3.29%,在复杂环境中也能提取完整裂缝,保证了裂缝检测的鲁棒性。     

一种基于实时几何测距的船桥主动防撞方法

本文提出一种基于实时几何测距的船桥主动防撞方法。该方法对船的改动量甚微,仅需维持多项距离矩阵,通过告警逻辑矩阵进行展示与告警,能起到很好的船桥防撞提示效果。     

Influence of Al3+ doping for V5+ on the structural,optical, thermal and electrical properties of V2-xAlxO5-δ (x=0–0.20) ceramics

This paper reports an investigation on the structure-properties correlation of trivalent metal oxide (Al₂O₃)-doped V₂O₅ ceramics synthesized by the melt-quench technique. XRD patterns confirmed a single orthorhombic V₂O₅ phase formation with increasing strain on the doping of Al₂O₃ in place of V₂O₅ in the samples estimated by Williamson-Hall analysis. FTIR and Raman investigations revealed a structural change as [VO₅] polyhedra converts into [VO₄] polyhedra on the doping of Al₂O₃ into V₂O₅. The optical band gap was found in a wide semiconductor range as confirmed by UV–visible spectroscopy analysis. The thermal and conductivity behavior of the prepared samples were studied using thermal gravimetric analysis (TGA) and impedance analyzer, respectively. All the prepared ceramics exhibit good DC conductivity (0.22–0.36 Sm^-1) at 400 ?C. These materials can be considered for intermediate temperature solid oxide fuel cell (IT-SOFC)/battery applications due to their good conductivity and good thermal stability.     

浅谈电子电工技术在电力系统中的应用

本文针对电子电工技术在电力系统中的作用进行了分析,同时为该技术的推广提出了相应的建议。     

Magnetic porous nano-carbon catalysts supported silver nanoparticles derived from chitin and their application in catalytic reduction reactions

The exploitation of recycled carbonaceous catalysts from renewable biomass resources such as chitin is a crucial issue for the development of the sustainable society. In this article, the chitin-based N and O doped carbon microspheres (ChC) were fabricated by a simple dissolution, sol–gel transformation, and the carbonization methods. Subsequently, the novel magnetic Ag-Fe₃O₄@chitin-based carbon microspheres catalyst (MChC) was successfully constructed through the in situ redox reaction. The as-prepared MChC possessed rich micropores with high-surface area, and a narrow size distribution (50–120 μm). The Ag-Fe₃O₄ nanoparticles were immobilized through the interaction with C, N, and O atoms in the pores of MChC. The reduction of 4-nitrophenol was applied to evaluate the catalytic activity of MChC. 4-Nitrophenol (4-NP) could be fully reduced to 4-aminophenol (4-AP) in 5 min with the catalyst MChC-45. Moreover, MChC could be collected in solution with an external magnet in 8 s and remained relatively high-catalytic activity after 10 cycle times. This work provided novel ideas for the fabrication of doped carbon material from biomass and promoted its utilization in nanocatalytic applications.     

Influence of surfactants on rheological behaviors of polyacrylonitrile/dimethyl sulfoxide/silicon blending polymer solutions

KH550, KH560, CTAB, and F127 were adopted to modify silicon (Si) to improve the dispersity and stability of Si in the polyacrylonitrile/dimethyl sulfoxide (PAN/DMSO) polymer solutions. The influence of surfactants on rheological behaviors of PAN/DMSO/Si blending polymer solutions was investigated by an advanced solution and melt rotation rheometer. The homogeneity and stability were also studied. The results showed that the surfactants could change the viscosity dependence of blending polymer solutions on shear rate, temperature and storage time by increase the steric hindrance of Si. Among the four solutions, PAN/DMSO/Si blending polymer solution with F127 exhibited the lowest viscosity, activation energy and the smallest structural viscosity index and exhibited the trend close to the Newtonian fluids. Moreover, PAN/DMSO/Si blending polymer solution with F127 exhibited the best dispersity and stability, indicating its best physical properties and machinability.     

Evolution of the electrical resistivity at rest and during oscillatory shearing of co-continuous morphology (PP/PMMA)/MWCNT systems

In this work, a modified parallel-disks configuration on a strain-controlled ARES rheometer (TA Instrument) was used to study the evolution of the electrical resistivity at rest and during oscillatory shearing of a co-continuous immiscible polymer blend morphology based on polypropylene and /polymethyl(methacrylate) (PP/PMMA) in which various amounts (0–3 wt%) of multiwall carbon nanotubes (MWCNT) were added. The co-continuity of both PP and PMMA phases allowed the buildup of a conductive network due to the preferential localization of the conductive MWCNT at the interface between PP and PMMA. Under a stepwise increase of the oscillatory strain amplitude below a critical value (γ_c = 6.3%), a significant decrease in the electrical resistivity was observed for MWCNT concentrations above the percolation threshold (0.3 wt%) due to the conductive paths induced by both thermal (Brownian) motion and oscillatory shearing. However, for deformation amplitudes higher than γ_c, the resistivity increased due to the destruction of the MWCNT paths induced by the large deformation imposed on the PP/PMMA interface. These observations were also confirmed by the evolution of the storage modulus (G′) which remained constant for γ_c < 6.3% (linear viscoelastic regime), while the values decreased above γ_c due to the destruction of the system's morphology.     

Combinations of Piperine with Hydroxypropyl-β-Cyclodextrin as a Multifunctional System

Piperine is an alkaloid that has extensive pharmacological activity and impacts other active substances bioavailability due to inhibition of CYP450 enzymes, stimulation of amino acid transporters and P-glycoprotein inhibition. Low solubility and the associated low bioavailability of piperine limit its potential. The combination of piperine with 2-hydroxypropyl-β-cyclodextrin (HP-β-CD) causes a significant increase in its solubility and, consequently, an increase in permeability through gastrointestinal tract membranes and the blood–brain barrier. X-ray powder diffraction (XRPD), differential scanning calorimetry (DSC), Fourier-transform infrared spectroscopy (FT-IR), nuclear magnetic resonance (NMR) were used to characterize interactions between piperine and HP-β-CD. The observed physicochemical changes should be combined with the process of piperine and CD system formation. Importantly, with an increase in solubility and permeability of piperine as a result of interaction with CD, it was proven to maintain its biological activity concerning the antioxidant potential (2,2-diphenyl-1-picryl-hydrazyl-hydrate assay), inhibition of enzymes essential for the inflammatory process and for neurodegenerative changes (hyaluronidase, acetylcholinesterase, butyrylcholinesterase).     

武汉市一般人群血清中全氟及多氟烷基化合物浓度及其影响因素研究

目的 了解武汉市一般人群血清中全氟及多氟烷基化合物(PFASs)浓度,探索血清中PFASs浓度水平的影响因素。方法 以在武汉市某医院进行一般体检的人群为研究对象(n=67),通过超高效液相色谱-三重四级杆质谱(UPLC-TQ/MS)联用仪测定外周血清中12种PFASs浓度,采用多元线性回归分析方法分析一般人口学特征和血清中PFASs浓度的关联性。结果 武汉市一般人群血清中12种PFASs的平均浓度水平为11.60 ng/mL。全氟辛烷磺酸及其盐类(PFOS)和全氟辛酸及其盐类(PFOA)的贡献率较大,分别为45.03%和31.86%。男性人群血清中PFOS、PFOA、全氟己基磺酸(PFHxS)、全氟壬酸(PFNA)等主要化合物的浓度高于女性,其β值(95%可信区间)分别为0.708(0.313,1.104)、0.518(0.069,0.967)、0.724(0.388,1.059)和0.684(0.399,0.968)。同时,发现血清中PFOS、PFHxS、PFNA浓度和年龄呈正相关,其β值(95%可信区间)分别为0.062(0.042,0.081)、0.035(0.019,0.052)和0.030(0.016,0.045)。结论 性别和年龄对血清中PFASs浓度有影响,在进行人体PFASs暴露评估中应考虑这些因素。